Hose Length Tolerance

The Hose Pro’s at TCH Industries explain what are the tolerances in hydraulic hose lengths, and how to proporly measure hose assemblies.

5 Misconceptions Video

Tolerances in Length of Hydraulic Hose Assemblies

Unless specified by your customer, hydraulic hose assemblies are measured from end to end. The only exception being assemblies with O-ring face seal end connections, in which they are measure from seat to seat. Make sure when measuring these assemblies that you pull back the nut to reveal the seat to achieve a proper length. If the end on the assembly is a 90- or 45-degree fitting, make sure the measurement cuts through the center of the angle. When you’re screwing into a port using a 45- or 90-degree fitting, you can come up short or long if you don’t measure through the center line. Considering jump sizes, the nuts on your end connections can be larger or smaller, so you need to make sure you are consistent. Please see the image below for a visual reference.

How to measure a hose correctly

Hydraulic Hose Length Tolerance

NAHAD lists the tolerance, determined by length, as shown below:

 

Tolerances for a hose up through 12 inches (304.8 mm) = 1/8″

 

A hose measuring 12 through 18 inces (304.8 through 457.2 mm) = 3/16″

 

A hose length of  18 through 36 inches (457.2 through 914.4 mm) = 1/4″

 

A hose assembly longer than 36 inches (914.4 mm) = 1% of the overall length

 

TCH Quick Tip

When building a hydraulic hose, it’s easy to cut the hose, insert the ends and measure to the length we’re looking for. For example, we cut and inserted ends to achieve a hose that was precisely twenty-six inches long, which grew nearly half an inch after crimping.

We measured a hose end-to-end at precisely 26 inches, using Danfoss’ H43020-100, 1-1/4-inch hose, along with their 4S-style 1-1/4-inch male JIC and male NPT end connections. After crimping, the hose assembly measured at just under 26.5 inches, nearly one-half of an inch in length.

When you crimp the ends on, the hose is going to grow, and this is something you need to keep in mind with assemblies, especially when the OAL is critical.

TCH Industries

We Are Hosers

Our focus and obsession is the distribution and fabrication of hose for industry and hose related products. Founded nearly 40 years ago, we are proudly owned and operated by the same family. Our manufacturing partners are some of the biggest and best names: Eaton, Parker, Dixon Valve, Hose Master, Brennen, Hannay Reels, and many others.

In short, we are a customer-centric hose company filled with happy professionals who can help you meet all your hose related needs. If you have any questions, please reach out to us by filling out the form below!

  • This field is for validation purposes and should be left unchanged.